Wrapping the basket loosely the first time let the concrete push the film out like blisters, some squares a full half inch proud. Pulled snug, three layers deep, the film gives even pillows about ¼ inch high.
You’ll also love: How to Make a Concrete Leaf Planter with Real Leaves, How to Make a Concrete Rope Lantern Over a Beach Ball, How to Make a Concrete Caterpillar with a Nylon Stocking Mold.
Our laundry basket planter is a tapered pot cast inside a plastic basket around a 5-gallon bucket: 15 inches across, 16 inches tall, about 90 pounds, with the basket’s grid standing out on every side.
Our neighbor knocked on it, said it looked like a waffle, and asked if we’d make one for her olive tree.
Tin snips go through basket plastic with a sharp crack, and the pieces spring off in every direction.

Where the Grid Pattern Comes From
Wet concrete pushes outward on the film wherever the basket has a hole. The plastic ribs hold it back, so each opening cures as a raised square.
We expected the basket to slide off like a mold. It won’t; the concrete locks into every opening, and the basket comes away in pieces.
A basket with smaller openings gives a finer, flatter pattern.
Materials & Tools
Not in the $95: the tree, a mixing tub and a hoe.
How much mix: the walls and base come to about 0.63 cubic feet, and one maker’s data sheet puts a 60-pound bag at about 0.5, so two bags leave a little over.
Where to cast it: 90 pounds is too much to carry far. Pour it where it will live, or on a plant dolly.
Other household molds: nursery pots do the same job for our draped concrete planters, with cloth giving the texture instead of a basket.
Watch the Build
Step by Step
Step 1Wrap the basket
Wind plastic wrap around the outside of the basket, from the bottom up, pulling it snug and overlapping each pass by 2 inches. Go around three times and tuck the end under the rim.
Pick a stiff basket. A floppy one bows out under the weight of the concrete and the pot comes out lopsided.

Step 2Pour the bottom
Mix one 60-pound bag with about 6 pints of water to a thick, sloppy oatmeal. Pour 2½ inches into the bottom of the basket and push the PVC piece straight down into the center until it touches bottom. Put a piece of tape over its top so the concrete can’t fill it.
Gloves and mask on; dry mix dust and wet cement both get into skin.

Step 3Set the bucket
Wipe cooking oil on the outside of the bucket and press it into the wet layer, centered over the drain, until its bottom sits about 2 inches above the basket’s. Fill it with water to hold it down.
An empty bucket floats up as the concrete goes in around it; 5 gallons of water weighs about 40 pounds and keeps it put.

Step 4Fill the walls
Mix the second bag and spoon it into the gap between bucket and basket, all the way around. Tap the basket sides with a rubber mallet as you go to work the mix into the corners of each opening.
Smooth the top rim flat with a gloved hand.

Step 5Cure and pull the bucket
Cover the top with plastic for 3 days. Bail out the water, twist the bucket and lift it out, then roll the planter onto a board upside down.
If the bucket won’t budge, pour a kettle of hot water into it and try again; the plastic gives a little as it warms.

Step 6Cut the basket off
Snip the rim first, then cut down the side ribs a section at a time and peel the plastic away. Pull gently where the concrete has wrapped around a rib, so you don’t snap a square off.
Safety glasses help here. Cut ribs spring loose with some force.

Step 7Peel and clean
Strip off the film and brush away any loose crumbs from the edges of the squares. Mist it and keep it under plastic for another week.

Step 8Seal and fill
After a month, brush on penetrating sealer, outside and rim. Set the laundry basket planter on pot feet and fill it with potting mix to 2 inches below the rim.

Step 9Plant it
Set the tree at the depth it grew in its nursery pot, firm the mix around it, and water until it runs from the drain.
A dwarf citrus like a Meyer lemon suits a pot this size. Full-size trees outgrow it within a couple of years.

How a Laundry Basket Planter Holds Up
The corners of the raised squares are what chip, usually when the pot gets dragged. Lift it with a dolly instead.
Concrete pulls lime out into the soil for the first few months, so acid-loving plants do better in it after it has weathered a season. Re-seal the outside once a year.
FAQ
Some squares came out blurry or flat
The film was loose there, or the mix was too stiff to push into the openings. Pull the wrap tighter and tap the sides longer on the next one.
The bottom cracked when we flipped it
It was flipped too soon or without a board under it. Give it the full 3 days, and roll it rather than lift it.
Can I use a basket with round holes?
Yes; you’ll get raised dots instead of squares. Any rigid basket with a regular pattern works the same way, and round holes fill a little more easily than square corners do.
Is a lemon tree happy in concrete?
For a few years, in a sunny spot. Citrus wants the pot to drain well and the soil to dry a little between waterings, and it will need a bigger pot as it grows.
Can it stay out in winter?
We haven’t left one out full of wet soil through a hard freeze. In cold places we’d move it somewhere sheltered, or empty it, rather than test it.
The olive tree got its planter two weeks later, from a basket with round holes. Our neighbor says hers is the better waffle.









