How to Make a Concrete Laundry Basket Planter with a Grid Texture

This post contains affiliate links. As an Amazon Associate I earn from qualifying purchases. Read the full disclosure.

Wrapping the basket loosely the first time let the concrete push the film out like blisters, some squares a full half inch proud. Pulled snug, three layers deep, the film gives even pillows about ¼ inch high.

You’ll also love: How to Make a Concrete Leaf Planter with Real Leaves, How to Make a Concrete Rope Lantern Over a Beach Ball, How to Make a Concrete Caterpillar with a Nylon Stocking Mold.

Our laundry basket planter is a tapered pot cast inside a plastic basket around a 5-gallon bucket: 15 inches across, 16 inches tall, about 90 pounds, with the basket’s grid standing out on every side.

Our neighbor knocked on it, said it looked like a waffle, and asked if we’d make one for her olive tree.

Tin snips go through basket plastic with a sharp crack, and the pieces spring off in every direction.

Concrete planter with a raised grid texture holding a young lemon tree

Project at a glance

Active time
About 2 hours
Cure time
3 days in the basket, 1 more week damp
Cost
About $95
Difficulty
Moderate
Finished size
15 in across, 16 in tall, about 90 lb

Where the Grid Pattern Comes From

Wet concrete pushes outward on the film wherever the basket has a hole. The plastic ribs hold it back, so each opening cures as a raised square.

We expected the basket to slide off like a mold. It won’t; the concrete locks into every opening, and the basket comes away in pieces.

A basket with smaller openings gives a finer, flatter pattern.

Materials & Tools

Plastic laundry basket with square openings1, about 15 in across the top and 16 in tall
Check on Amazon
Sand/topping mix2 bags, 60 lb
Plastic wrap1 roll
Check on Amazon
5-gallon bucket1 — the inside of the pot
Check on Amazon
PVC pipe, 1 inA 2½-in piece — the drain
Tin snips1
Check on Amazon
Nitrile gloves and a dust mask1 box, 1 mask
Check on Amazon
Penetrating concrete sealer1 qt
Check on Amazon
Potting mix1 bag, 1.5 cu ft

Not in the $95: the tree, a mixing tub and a hoe.

How much mix: the walls and base come to about 0.63 cubic feet, and one maker’s data sheet puts a 60-pound bag at about 0.5, so two bags leave a little over.

Where to cast it: 90 pounds is too much to carry far. Pour it where it will live, or on a plant dolly.

Other household molds: nursery pots do the same job for our draped concrete planters, with cloth giving the texture instead of a basket.

Watch the Build

Step by Step

Step 1Wrap the basket

Wind plastic wrap around the outside of the basket, from the bottom up, pulling it snug and overlapping each pass by 2 inches. Go around three times and tuck the end under the rim.

Pick a stiff basket. A floppy one bows out under the weight of the concrete and the pot comes out lopsided.

Wrapping plastic film tightly around the outside of an orange laundry basket

Step 2Pour the bottom

Mix one 60-pound bag with about 6 pints of water to a thick, sloppy oatmeal. Pour 2½ inches into the bottom of the basket and push the PVC piece straight down into the center until it touches bottom. Put a piece of tape over its top so the concrete can’t fill it.

Gloves and mask on; dry mix dust and wet cement both get into skin.

Pouring concrete mix into the plastic-wrapped laundry basket

Step 3Set the bucket

Wipe cooking oil on the outside of the bucket and press it into the wet layer, centered over the drain, until its bottom sits about 2 inches above the basket’s. Fill it with water to hold it down.

An empty bucket floats up as the concrete goes in around it; 5 gallons of water weighs about 40 pounds and keeps it put.

Pressing a white bucket into the wet concrete inside the basket

Step 4Fill the walls

Mix the second bag and spoon it into the gap between bucket and basket, all the way around. Tap the basket sides with a rubber mallet as you go to work the mix into the corners of each opening.

Smooth the top rim flat with a gloved hand.

Concrete filling the gap between the bucket and the basket

Step 5Cure and pull the bucket

Cover the top with plastic for 3 days. Bail out the water, twist the bucket and lift it out, then roll the planter onto a board upside down.

If the bucket won’t budge, pour a kettle of hot water into it and try again; the plastic gives a little as it warms.

Upside-down concrete planter with the laundry basket being lifted away

Step 6Cut the basket off

Snip the rim first, then cut down the side ribs a section at a time and peel the plastic away. Pull gently where the concrete has wrapped around a rib, so you don’t snap a square off.

Safety glasses help here. Cut ribs spring loose with some force.

Cutting the laundry basket away from the concrete with snips

Step 7Peel and clean

Strip off the film and brush away any loose crumbs from the edges of the squares. Mist it and keep it under plastic for another week.

Concrete planter with a raised grid texture after the basket comes off

Step 8Seal and fill

After a month, brush on penetrating sealer, outside and rim. Set the laundry basket planter on pot feet and fill it with potting mix to 2 inches below the rim.

Filling the laundry basket planter with potting mix

Step 9Plant it

Set the tree at the depth it grew in its nursery pot, firm the mix around it, and water until it runs from the drain.

A dwarf citrus like a Meyer lemon suits a pot this size. Full-size trees outgrow it within a couple of years.

Planting a young lemon tree in the concrete planter

How a Laundry Basket Planter Holds Up

The corners of the raised squares are what chip, usually when the pot gets dragged. Lift it with a dolly instead.

Concrete pulls lime out into the soil for the first few months, so acid-loving plants do better in it after it has weathered a season. Re-seal the outside once a year.

FAQ

Some squares came out blurry or flat

The film was loose there, or the mix was too stiff to push into the openings. Pull the wrap tighter and tap the sides longer on the next one.

The bottom cracked when we flipped it

It was flipped too soon or without a board under it. Give it the full 3 days, and roll it rather than lift it.

Can I use a basket with round holes?

Yes; you’ll get raised dots instead of squares. Any rigid basket with a regular pattern works the same way, and round holes fill a little more easily than square corners do.

Is a lemon tree happy in concrete?

For a few years, in a sunny spot. Citrus wants the pot to drain well and the soil to dry a little between waterings, and it will need a bigger pot as it grows.

Can it stay out in winter?

We haven’t left one out full of wet soil through a hard freeze. In cold places we’d move it somewhere sheltered, or empty it, rather than test it.

The olive tree got its planter two weeks later, from a basket with round holes. Our neighbor says hers is the better waffle.

You Might Also Love

Owen Carter

I write the guides on Canonigos. Every project comes with its video, a materials list and the measurements you need to build it yourself.

Leave a Comment